...continuing the Mini RC Car build.
To attach the steering servo, I drilled holes in the frame and bolted the two together.
I then hot-glued the front frame to the rear half, making sure I had enough ground clearance and all 4 tires on the ground.
The next step was creating a board that would support the Arduino chip, a socket for the bluetooth breakout board, the 3.3v voltage regulator and a socket for the servo connector. Here's the prototype:
After a bit of soldering, here what I have so far:
Now that I have all the main components, I'll do the final assembly and start programming the on-board Arduino code and the Android controller app.
To view the whole project, go here
google 3832
ReplyDeletegoogle 3833
google 3834
google 3835
google 3836